[time-nuts] GPS antenna in silicon/RTV encapsulation
lester at veenstras.com
Thu Apr 17 18:09:11 UTC 2014
The classic DIY test of material for RF use is give it 60 seconds in a
If it gets warm, its not a good candidate.
The other more typical concern with "RTV" type materials are the ones using
acetic acid to cure. This outgases, condenses with water vapor to form an
corrosive material on the electronics inside a "sealed" environment. When
the unit mails, and you look inside, you find lots of "green" corrosion
inside, to the point interconnects fail. There are electronic friendly forms
of the sealant that do not have the vinegar odor.
Lester B Veenstra MØYCM K1YCM W8YCM
lester at veenstras.com
US Postal Address:
5 Shrine Club Drive
HC84 Box 89C
Keyser WV 26726
GPS: 39.336826 N 78.982287 W (Google)
GPS: 39.33682 N 78.9823741 W (GPSDO)
US cell +1-304-790-9192
UK cell +44-(0)7849-248-749
Guam Cell: +1-671-929-8141
This e-mail and any documents attached hereto contain confidential or
privileged information. The information is intended to be for use only by
the individual or entity to whom they are addressed. If you are not the
intended recipient or the person responsible for delivering the e-mail to
the intended recipient, be aware that any disclosure, copying, distribution
or use of the contents of this e-mail or any documents attached hereto is
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Jim Lux
Sent: Monday, April 14, 2014 11:32 PM
To: time-nuts at febo.com
Subject: Re: [time-nuts] GPS antenna in silicon/RTV encapsulation
On 4/14/14, 12:11 PM, EWKehren at aol.com wrote:
> Am experimenting with small low cost GPS antennas and am considering
> as an alternative RTV/silicon. Any information on RF attenuation of
> RTV/silicon at 1.6 GHz ?
Are you potting the antenna in a solid mass of silicone? Or using it to seal
an enclosure or what?
pure silicone is very low loss, and it probably has an epsilon around 3.
It can be loaded with silica (which is also low loss) to adjust the
mechanical properties and electrical properties. It can also be loaded
with other things (TiO2) which will increase the epsilon, but also the
the plastics that are notorious for loss are ones that have metal or carbon
loading or that are hygroscopic so they pick up water.
In the clear plastics world, Polypropylene, polyethylene and polystrene are
pretty good. Polycarbonate isn't as good, neither are various acetals
(Delrin) and acetates
Here's a chart
or another chart
here's a whole report from Dow on silcone rubbers as dielectrics
They give quite low loss tangents at 10^9 cps (which I looked up on my cps
to Hz conversion chart.. That's in your frequency range) 0.0059 loss tangent
for Silastic 80.
The trick for you will be knowing what else is in your particular silicone
resin, and controlling the water content.
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
and follow the instructions there.
More information about the Time-nuts_lists.febo.com