[time-nuts] FASTTRAX GPS Antenna power
Bob Stewart
bob at evoria.net
Fri Jul 11 05:02:49 UTC 2014
I'm a bit confused about what you're asking. You discuss antennas but you show pictures of a GPS receiver. They're not the same thing. I use a puck antenna. They cost about $6 on ebay, and take their power from the coax. Normally your GPS receiver supplies power to the coax, so you don't have to do anything special, other than don't short it out.
Bob
________________________________
From: jim s <jwsmail at jwsss.com>
To: time-nuts at febo.com
Sent: Thursday, July 10, 2014 11:49 PM
Subject: [time-nuts] FASTTRAX GPS Antenna power
I disobeyed the group suggestions about antennas, and bought one of the
one which needs power.
I had asked whether I should apply 5 volts to the.
tom posted on his fine info page a pinout, which I'm going to use.
Pin 1 is 3-5.5VDC Antenna power input.
Pin 2 is Prime Power input
pin 4 is Backup Power input.
Pin 8 is GND
I am going to apply 3.3 to 1,2, and 4. Just wanted to get an opinion
before trying it.
I'm curious if somehow the suggested Primary and Backup power was all
that was needed, or how you guys were getting your GPS signals in. Are
your antennas not powered?
thanks
Jim
http://leapsecond.com/pages/itrax/
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list