[time-nuts] BeagleBone Black NTP server
nuts at lazygranch.com
Sat May 10 03:38:11 UTC 2014
On Fri, 9 May 2014 21:59:22 -0500
Bill Dailey <docdailey at gmail.com> wrote:
> I have the adafruit and a ublox-6T each mated to raspberry pi's.
> With NTP they are essentially indistinguishable. I have something
> other than NTP in mind for the 6Tpi.
> Sent from my iPad
> > On May 9, 2014, at 9:32 PM, Brian Lloyd <brian at lloyd.com> wrote:
> > On Fri, May 9, 2014 at 8:49 PM, Chris Albertson
> > <albertson.chris at gmail.com>wrote:
> >>> On Fri, May 9, 2014 at 1:55 PM, Brian Lloyd <brian at lloyd.com>
> >>> wrote:
> >>> Has anyone here made NTP run on BBB? My plan is to run NTP
> >>> disciplined by my Trimble Thunderbolt on BBB.
> >> NTP is likely already installed on the BBB. It ships with the BBB.
> > That may be the case for the Angstrom distro but it is not the case
> > for the Debian distro, which seems to be the future direction of
> > BBB.
> >> Some
> >> configuration is needed to enable the service. Do this first and
> >> verify you can run using Internet pool servers. Then after this
> >> is running you physically connect your GPS then add lines in NTP's
> >> config file telling NTP you have added another ref. clock.
> > This link:
> > http://the8thlayerof.net/2013/12/08/adafruit-ultimate-gps-cape-creating-custom-beaglebone-black-device-tree-overlay-file/
> > Seems to have the bulk of the requisite information including
> > building a GPS cape using the Adafruit GPS module. See:
> > https://www.adafruit.com/product/746
> > This isn't a timing receiver but would probably be adequate for
> > NTP. But since I already have a T-bolt I figured I would use that
> > as my timing source.
> > --
I can tell you that the BBB is really reliable. You don't hear that
about the R. Pi, plus it is about 4x the CPU power of the R PI,
granted at $20 more cost. The R Pi has a better GPU if you need
I'm running dump1090 on the BBB, for those familiar with the project.
[Probably just "satellite Dave."]
The only issue I found with the BBB is when I booted my router and the
connection to the BBB didn't fire up. I probed the BBB with the serial
port connector and it was running just fine, so I don't know why the
router didn't connect to it. I booted the BBB and it did connect to the
Reliability is of course key to any timing reference. Angstrom uses
systemd. The R Pi is still on initd IIRC.
Note a bug on the BBB is if you use a cape, it blocks the connector to
the serial port.
More information about the Time-nuts_lists.febo.com