[time-nuts] Clock level conversion 5V -> 3.3V
Mark A. Haun
haunma at keteu.org
Wed Oct 1 02:11:59 UTC 2014
The OCXO is one of those 26-MHz ebay Pletronics from a couple years
back. I would like to not degrade its close-in phase noise (quoted as
-100 dBc @ 10 Hz, -130 dBc @ 100 Hz). Thinking about Said's suggestion
to phase lock a higher-frequency sampling clock to this, with a loop BW
somewhere in the 10-100 Hz range.
I have seen a resistive divider used in a similar application, but
wondered if I could save the couple dozen mA they were spending.
On Tue, 30 Sep 2014 20:18:56 -0400
Bob Camp <kb8tq at n1k.org> wrote:
> How quiet does it need to be?
> Put another way - how good is the OCXO?
> What frequency are we talking about?
> What is the phase noise “need” after you get to 3.3V (is there a
> system spec)?
> On Sep 30, 2014, at 5:46 PM, Mark Haun <haunma at keteu.org> wrote:
> > Is there a "best" way to do this without adding phase noise? For
> > example, a 5V OCXO into an ADF4002, or a 3.3V or even 1.8V logic
> > input. Is a resistive divider the way to go?
> > Mark
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow
> > the instructions there.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow
> the instructions there.
More information about the Time-nuts_lists.febo.com