[time-nuts] How long do ovens take to cool to ambient after power is removed?
Richard (Rick) Karlquist
richard at karlquist.com
Thu Oct 2 04:03:55 UTC 2014
On 10/1/2014 1:04 PM, Hal Murray wrote:
> drkirkby at kirkbymicrowave.co.uk said:
>> Anyway, later today (tomorrow ??) I will post a plot of frequency vs time.
>> The question is though, how long is thing thing likely to take too cool?
> I'd expect an exponential decay so you need to specify how close to ambient
> you want to get. I'd guess a ballpark of 10x the warm up rate.
> You can probably measure it if you have the warmup graph. Turn it off, wait
> a while, turn it on, measure the freq, consult warmup graph.
When I was still with Agilent, I did some experiments with unpowered
10811's. Both the oven and oscillator were unpowered and I measured
the temperature by looking at the B mode resonance of the crystal.
I wanted to get rid of any linear frequency drift. As a rough
rule of thumb, 1 hour of cool down is pretty good for most purposes.
For extreme measurements, I would allow 10 hours. This reduced
any exponential tail to below the ability to measure temperature and/or
below the effects of the ambient. I had to put a box over it to
reduce the effects of air currents. If I did not do that, then 1 hour
was all I needed.
Rick Karlquist N6RK
More information about the Time-nuts_lists.febo.com