[time-nuts] HP10811-60212-B Pinouts.
john at miles.io
Fri Oct 10 23:58:24 UTC 2014
I'm not familiar with the 10811-60212 variant, but I have a -60168 single oven part whose 6-pin connector is wired like this:
RED Oscillator power +11.5-13V
YEL Oven monitor
GRN Oven power +20-30V
BLU Oven ground
The coax connectors are probably SMB (J1=EFC, J2=10 MHz out).
Schematics will be comparable to the rest of the 10811 series, as seen in http://www.leapsecond.com/museum/10811a/10811a.pdf .
The red and gray wires probably go to the outer oven and its associated thermistor, if the -60212 is a DOCXO. Sounds like it is from what you're saying. No guarantee that the pinout above will work with your oscillator, so use caution when powering it up for the first time.
-- john, KE5FX
Miles Design LLC
> -----Original Message-----
> From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of
> dan at irtelemetrics.com
> Sent: Friday, October 10, 2014 4:32 PM
> To: time-nuts at febo.com
> Subject: [time-nuts] HP10811-60212-B Pinouts.
> Hi All,
> I recently picked up an HP10811-60212-B oscillator. However I don't
> happen to have the pinouts for this device.
More information about the Time-nuts_lists.febo.com