[time-nuts] float chargers for oscillator backup power
kb8tq at n1k.org
Mon Oct 27 11:42:03 UTC 2014
Based on reports on the earlier Z3xxx’s , I would be careful about the low end of that supply range. There’s still way more range than you would ever need …
> On Oct 26, 2014, at 11:42 PM, Bob Stewart <bob at evoria.net> wrote:
> Hi Bob,
> The little brick says it's happy with 18-36V.
> From: Bob Camp <kb8tq at n1k.org>
> To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
> Sent: Sunday, October 26, 2014 10:37 PM
> Subject: Re: [time-nuts] float chargers for oscillator backup power
> We seem to have drifted a bit.
> This started out as a supply for the Z3xxx Lucent GPSDO’s. In those units, you have a 24 volt switcher that is driven off of the battery or linear supply. Since it’s designed as an isolated supply, I doubt the switcher in the GPSDO is looking for a very clean input. The same is true of it’s need for a tightly regulated input. Yes it’s efficiency will vary a bit with input and so will heat in the box. Still, not a real big deal if the voltage drops a volt or so when you go onto backup. The GPS is still running to keep everything lined up.
> How fast to you need to re-charge the battery bank? For me, not very fast. To keep the batteries healthy, maybe a bit faster than I would like. Lower charge current is another reason to go with a smaller battery if you can get away with it.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com