[time-nuts] Motorola Oncore UT+ firmware upgrade & backup power questions

Pete Stephenson pete at heypete.com
Sun Jun 21 06:24:32 UTC 2015


The Oncore driver can load certain parameters (e.g. the fixed
location, mode of operation, and -- I think -- the current estimated
time) into the Oncore receiver's RAM, but doesn't do anything to the
firmware on flash.

Cheers!
-Pete

On Sun, Jun 21, 2015 at 1:06 AM, Hal Murray <hmurray at megapathdsl.net> wrote:
>
> gigneil at gmail.com said:
>> I didnt see this well answered - the device loads firmware at each start
>> cycle.  If i am not mistaken you can even use ntp.
>
> I just scanned the ntp source code for the Oncore driver.  I didn't see any
> hints of loading firmware.  There is code to read the firmware version.
>
> --
> These are my opinions.  I hate spam.
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.



-- 
Pete Stephenson



More information about the Time-nuts_lists.febo.com mailing list