[time-nuts] New Member + Basic Questions
rob at nc0b.com
Sat Jan 16 16:32:19 UTC 2016
I did some interpolation to compare the specs for phase noise of the 8660 the way it was done then to the present method. I think it is going to be something like -105 dBc/Hz to -110 dBc/Hz at 10 kHz offset at 14 MHz carrier frequency.
As a comparison, the 8662A is about -135 dBc/Hz and the 8642A is better than -150 dBc/Hz.
Actual measurements on multiple generators in my lab. Unfortunately I have never used or measured an 8660.
3335A -128 dBc/Hz
3336C -120 dBc/Hz
3325A -115 dBc/Hz (original version. Later improved by 4 pr 5 dB after the 3336C came out.)
As a comparison a Rigol DG4162 is -115 dBc/Hz
All at 10 kHz offset and on the 20 meter band.
It depends what you are trying to measure. Sensitivity or noise floor, anything will work within the range of specified output accuracy and leakage. On the other hand, if you are trying to measure the dynamic range of a receiver, or its phase noise characteristics, you cannot do that with most generators.
Sent from my iPad
> On Jan 16, 2016, at 3:10 AM, "Richard (Rick) Karlquist" <richard at karlquist.com> wrote:
>> On 1/14/2016 12:35 PM, Nathan Johnson wrote:
>> What does the group think of the HP 8660? Just scored a broken one too cheap to
>> pass up. I know it's not gonna be the last signal generator I buy, but for under
>> $100 shipped it should be an interesting project.
>> Nathan KK4REY
> When I worked at HP, I had the chance to discuss this product
> with various engineers who were involved in its development.
> It frankly wasn't one of the better products in the line.
> It has a high broadband noise floor. The follow on
> product, the 8662, is MUCH better. No comparison.
> Rick Karlquist N6RK
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> If this email is spam, report it to
More information about the Time-nuts_lists.febo.com