[time-nuts] OCXO Vectron 218Y44442

Jim Harman j99harman at gmail.com
Mon Oct 16 22:22:50 UTC 2017

In your image ...125 it looks like there is a cold solder joint near the
bottom right, in the second "column" of pads, 3 pads up from the bottom.

On Mon, Oct 16, 2017 at 4:10 PM, Vlad <time at patoka.org> wrote:

> Hello,
> I am wandering if anybody observe the behavior for OCXO, when its stop to
> reproduce the signal, and the only way to return it back to business is
> little mechanical stress.
> I have TWO of such OCXO. One of them is Austron 11.2 Mhz. And another one
> is Vectron model 218Y4442 9.8304Mhz
> In case with Vectron, I even disassemble it (to whom who brave here is a
> pictures):
> http://www.patoka.ca/Vectron-218Y44442/
> Then as I connect it to the PS, I realize it start to reproduce the signal
> again ! Before this it was nothing ! I tried different PS before to open
> this "can" as a last resort.
> For the Austron - I didn't disassemble it. Instead I just kick it a little
> bit. And immediately after that, it start to produce the signal !
> --
> WBW,
> V.P.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/m
> ailman/listinfo/time-nuts
> and follow the instructions there.


--Jim Harman

More information about the Time-nuts_lists.febo.com mailing list