[time-nuts] Re: VT100 Terminal: Symmetricom TimeSource 3500

[Herman Karst]

Hi Adam,

You can also use TimeCraft software to control the unit. You can download it from the Microchip website. 

 
Met vriendelijke groet | With kindest regards | Cordialement | Med vennlig hilsen | Mit freundlichen Grüßen,
 
Richard Karst
PA1FYB
9761 EV Eelde  



 

> Op 11 nov 2024 om 22:19 heeft Adam Kuzych via time-nuts <time-nuts at lists.febo.com> het volgende geschreven:
> 
> I have a Symmetricom TimeSource 3500 of unknown origin that appears to boot
> correctly, by LED action, and operates the Rb 10MHz output, but is perhaps
> undisciplined by GPS.
> 
> I've read through the manual extensively, and have copied the craft port
> pinout to the working serial port on an ancient Windows XP computer running
> Hyperterminal VT100, 9600 8N1.
> 
> I've tried adding an unnecessary null, and tried access as well to the
> DB-25 rear serial connector, null in and out there too, without success. No
> joy in PuTTY on a modern PC either.
> 
> I've done plenty of terminal into other obsolete gear of this era, and
> never had these problems with this much effort. Could someone reach me who
> has had success on this model series?
> 
> Opening it up, there doesn't appear to be any factory reset switch or any
> memory battery to pull here.
> 
> I may be able to try something Wireshark to the ethernet port, but I don't
> think they intended that access for control on this model.
> 
> 
> 
> Adam VE6WMR
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe send an email to time-nuts-leave at lists.febo.com