[time-nuts] Re: Custom Wenzel OXCO with unusual output

[Walt]

No, that didn’t change anything.

 

And speaking of termination, the output level I cited below (4.4 Vpp) was without a 50 ohm load.

 

The actual output level into 50 ohms is 2.8 Vpp.

 

From: paul swed <paulswedb at gmail.com> 
Sent: Sunday, April 6, 2025 11:36 AM
To: Discussion of precise time and frequency measurement <time-nuts at lists.febo.com>
Cc: Walt <walt at drizzle.com>
Subject: Re: [time-nuts] Custom Wenzel OXCO with unusual output

 

Walt, try terminating it in 50 ohms. See if that helps.

Paul

WB8TSL

 

On Sun, Apr 6, 2025 at 12:32 PM Walt via time-nuts <time-nuts at lists.febo.com <mailto:time-nuts at lists.febo.com> > wrote:

I picked up a custom Wenzel 500-13248B quartz oscillator and upon measuring
it, I'm not sure if it is working as designed or what.

The RF Out is a raggedy 10MHz sine wave at 4.4Vpp, and a spectrum analyzer
shows peaks at 10, 20, 30, 40, 50, 60 and 70 MHz.  There may be more but I'm
not sure how to acquire them.

There is nothing coming out of the second unmarked SMA.

Assuming this is not broken, what kind of oscillator is this, and what would
it be used for?
_______________________________________________
time-nuts mailing list -- time-nuts at lists.febo.com <mailto:time-nuts at lists.febo.com> 
To unsubscribe send an email to time-nuts-leave at lists.febo.com <mailto:time-nuts-leave at lists.febo.com>