[time-nuts] OT: Prologix GPIB and HP3478A...The Answer!

John Miles jmiles at pop.net
Thu Nov 29 00:43:58 EST 2007

It sounds obvious, but make sure the board is pressed all the way onto the
connector.  The housing makes it a little bit difficult to tell if the GPIB
connection is properly seated.  This has tripped me up before.

-- john, KE5FX

> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com]On
> Behalf Of Chuck Harris
> Sent: Wednesday, November 28, 2007 7:43 PM
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] OT: Prologix GPIB and HP3478A...The Answer!
> Hi Didier,
> I am more and more coming to the conclusion that my 3478A is just fine,
> but my Prologix adapter is a victim of infant mortality.
> It can't address my Tektronix 7854 either.
> -Chuck Harris
> Didier Juges wrote:
> > I am aware of at least 2 more 3478 at my workplace, one of them
> actually has
> > been in my office for so long I forgot about it. It has worked
> fine with the
> > older Prologix controller (the one without a case,) with
> nothing else on the
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list