[time-nuts] T-Bolt Schematic
Bob Camp
lists at cq.nu
Sun Feb 14 04:18:09 UTC 2010
Hi
I do believe that the Tbolt runs fine with TX, RX, and ground on the RS-232. The other six pins are available.
I'd probably double up the pins for power and ground.
Bob
On Feb 13, 2010, at 11:06 PM, Richard W. Solomon wrote:
> Does anyone have a copy of the schematic for the Trimble T-Bolt ?
>
> I need to know if there is an unconnected pin on the RS-232 connector
> that I can run +12 vdc through.
>
> Thanks, Dick, W1KSZ
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list