[time-nuts] T-Bolt Schematic

[Robert Atkinson]

Hi,I'm sure you know this, but using the handshake pins (RTS, CTS, DCD, DTR) Is a good idea from the point of protection if someone plugs a standard lead in. Use output pins if you are sending power out, input if sending in.
Robert G8RPI.

--- On Sun, 14/2/10, Richard W. Solomon <w1ksz at earthlink.net> wrote:

From: Richard W. Solomon <w1ksz at earthlink.net>
Subject: [time-nuts] T-Bolt Schematic
To: time-nuts at febo.com
Date: Sunday, 14 February, 2010, 4:06

Does anyone have a copy of the schematic for the Trimble T-Bolt ?

I need to know if there is an unconnected pin on the RS-232 connector
that I can run +12 vdc through.

Thanks, Dick, W1KSZ

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.