[time-nuts] Z3805 utility, Was: AW: (no subject)

Ulrich Bangert df6jb at ulrich-bangert.de
Sat May 22 09:50:13 UTC 2010


everything you need for the Z3805 is included in my Z38XX utility, that has
already been mentioned. This includes sending commands to the receiver, you
do not need another terminal program. I own a Z3805 myself and basically I
have written the software for myself. A Z3801 manual in conjunction with
Z38XX should take you pretty far in either get it to run or otherwise
diagnose a fault. 

Best regards
Ulrich Bangert

> -----Ursprungliche Nachricht-----
> Von: time-nuts-bounces at febo.com 
> [mailto:time-nuts-bounces at febo.com] Im Auftrag von Robert Benward
> Gesendet: Samstag, 22. Mai 2010 03:15
> An: time-nuts at febo.com
> Betreff: [time-nuts] (no subject)
> Hi,
> I just purchased a Z3805A at the Dayton hamfest this past 
> weekend.  How do I 
> get it to work?  Do I need software to run this, or can it 
> run stand alone. 
> I have turned it on, but only the power light comes on, the 
> GPS lock, and 
> more importantly, the enable light is not on.  There is an 
> 10MHz output, but 
> the holdover light is not on.  Is there any freeware available?  Any 
> recommendations?
> Any opinions on this one:
> http://cgi.ebay.com/GPS-Receiver-Program-HP-Z3801A-Z3805A-Z381

Thank you in advance.

time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
and follow the instructions there.

More information about the time-nuts mailing list