[time-nuts] Rb vs.Crystal OCXO
saidjack at aol.com
Sun Apr 27 21:14:08 UTC 2014
There is an easier method that does not jiggle the board mechanically:
Disables the disciplining.
The sync:tint? command can be used to check the drift while in holdover..
Sent From iPhone
On Apr 27, 2014, at 10:04, Bill Dailey <docdailey at gmail.com> wrote:
> I unplug the antenna from my fury boards. I hope this is an effective alternative.
> Sent from mobile
> On Apr 27, 2014, at 9:02 AM, "Tom Van Baak" <tvb at LeapSecond.com> wrote:
>>> The Pendulum GPS-88 and GPS-89 have a button on the front you push when
>>> you want to force it into hold-over to do your measurement, for this
>>> very reason.
>>> PPS steering and OCXO steering is the same thing once you forced the PPS
>>> into the right range. Some *really* depend on the synchronicity between
>>> 10 MHz and PPS, and you should not obscure it if possible.
>> When doing a sensitive measurement where stability is more important than accuracy I turn off GPS disciplining.
>> The TBolt has commands to go into and out of holdover. But more effective are the 0x8E,0xA3,4 and 0x8E,0xA3,5 commands which simply disable and enable disciplining.
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com