[time-nuts] HP E3610A Power supply
EWKehren at aol.com
EWKehren at aol.com
Thu May 22 19:18:41 UTC 2014
Brooke NO
Bert
In a message dated 5/22/2014 3:12:56 P.M. Eastern Daylight Time,
brooke at pacific.net writes:
Hi Bert:
My E3617A has a front panel adjustment screw for Over Voltage Protection.
Does the E3610 have that?
http://www.prc68.com/I/Capacitors.shtml#SupCMeas
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.end2partygovernment.com/2012Issues.html
EWKehren at aol.com wrote:
> This may be off topic but I did check with Tom and many time nuts may
have
> HP E3610A power supplies on their bench and mine smoked a ublox GPS so
that
> makes it topic related..
> The reference section has some 1 uF 50V capacitors and in my unit one
> shorted. The reference section has fuses on the board but they did not
open. The
> 7912 overheated and shorted out, traces are discolored the op amp
shows
> signs of overheating and burned out. The result was the output went to
30V+
> and next morning the ublox chip plastic showed where the chip smoked.
As
> a minimum I recommend replacing the 1 uF capacitors with new quality
caps,
> I also ordered 15 V 5 W zeners and 0.5 A 20 mm glass fuses.
> Bert Kehren
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list