[time-nuts] My HP 5370B reads 6 nS out!
magnus at rubidium.dyndns.org
Sun Jun 14 22:01:42 UTC 2015
On 06/13/2015 06:48 PM, Peter Reilley wrote:
> I just got a new (to me) HP 5370B and I wanted to try it out on the 1 PPS
> from a Trimble Resolution T. Using 10K samples averaging it is always
> 6 or 7 nS to high. Shouldn't this average toward zero? If I use no
> it bounces around within the expected range.
> I have done this test using the internal oscillator and an external rubidium
> standard. I get the about the same results in both cases.
> I did calibrate the OCXO in the 5370B using the rubidium standard and got it
> that there is less than one cycle difference between the two over a period
> of a few
> I have tried a number of GPS units with the same result.
> Could my rubidium oscillator be that far out? It is a FEI model FE5680A.
> Am I missing something?
It is not entirely clear to me what you measure, PPS and later 10 MHz
There can be a time-offset between the start and the stop channels.
Just adjusting the OCXO does not help for that.
Dig up the service manual and check there.
More information about the Time-nuts_lists.febo.com