[time-nuts] Re: Industry standard scpi command set for counters or frequency references?

[Herman Karst]

Hi Erik,

I think the Agilent/Keysight counters are understood by most automation programs like LabView or Keysight VEE. 
  
 
Met vriendelijke groet | With kindest regards | Cordialement | Med vennlig hilsen | Mit freundlichen Grüßen,
 
Richard Karst
PA1FYB
 



 

> Op 25 mei 2024 om 12:05 heeft Erik Kaashoek via time-nuts <time-nuts at lists.febo.com> het volgende geschreven:
> 
> While working on the implentation of scpi control, it became clear there
> are substantial differences between available implementations.
> My initial thought was to use the FS740 from SRS as inspiration as this
> also  contains both a multi channel timer counter and a gpsdo, but the
> FS740 is not very new, it may be a wrong choice.
> While basic MEASURE, CONFIG and READ commands seem to be fairly common, a
> clear difference with , for instance, Siglent counters is how the channel
> selection is done.
> Does anyone have a recommendation on what scpi command set to use as
> inspiration to provide largest communality and easy learning and usage?
> Erik
> _______________________________________________
> time-nuts mailing list -- time-nuts at lists.febo.com
> To unsubscribe send an email to time-nuts-leave at lists.febo.com